XSslimbh¶
-
class
sherpa.astro.xspec.
XSslimbh
(name='slimbh')[source] [edit on github]¶ Bases:
sherpa.astro.xspec.XSAdditiveModel
The XSPEC slimbh model: Stationary slim accretion disk.
The model is described at [1]. The
set_xsxset
andget_xsxset
functions are used to set and query the XSPEC XSET “SLIMBB_DEBUG”, “SLIMBB_DIR”, and “SLIMBB_TABLE” parameters.-
M
¶ The mass of the black hole, in M_sol.
-
a
¶ The black hole spin parameter.
-
lumin
¶ The total disk luminosity in Eddington units.
-
alpha
¶ alpha-viscosity
-
inc
¶ The inclination, in degrees.
-
D
¶ The distance to the source, in kpc.
-
f_hard
¶ The hardening factor. A negative value means to use TLUSTY spectra.
-
lflag
¶ A flag to control the effect of limb-darkening. If greater than zero then the disk emission is limb-darkened, otherwise it is assumed to be isotropic.
-
vflag
¶ A flag to contorl the surface profile. If greater than zero, raytracing is done from the actual photosphere, otherwise the spectrum is raytraced from the equatorial plane ignoring the height profile of the disk.
Notes
This model is only available when used with XSPEC 12.9.1 or later.
References
[1] (1, 2) https://heasarc.gsfc.nasa.gov/xanadu/xspec/manual/XSmodelSlimbh.html Attributes Summary
thawedparhardmaxes
thawedparhardmins
thawedparmaxes
thawedparmins
thawedpars
version_enabled
Methods Summary
apply
(outer, *otherargs, **otherkwargs)calc
(pars, xlo, *args, **kwargs)get_center
()guess
(dep, *args, **kwargs)Set an initial guess for the parameter values. regrid
(*arrays)reset
()set_center
(*args, **kwargs)startup
()Called before a model may be evaluated multiple times. teardown
()Called after a model may be evaluated multiple times. Attributes Documentation
-
thawedparhardmaxes
¶
-
thawedparhardmins
¶
-
thawedparmaxes
¶
-
thawedparmins
¶
-
thawedpars
¶
-
version_enabled
= True¶
Methods Documentation
-
apply
(outer, *otherargs, **otherkwargs) [edit on github]¶
-
calc
(pars, xlo, *args, **kwargs) [edit on github]¶
-
get_center
() [edit on github]¶
-
guess
(dep, *args, **kwargs) [edit on github]¶ Set an initial guess for the parameter values.
Attempt to set the parameter values, and ranges, for the model to match the data values. This is intended as a rough guess, so it is expected that the model is only evaluated a small number of times, if at all.
-
regrid
(*arrays) [edit on github]¶
-
reset
() [edit on github]¶
-
set_center
(*args, **kwargs) [edit on github]¶
-
startup
() [edit on github]¶ Called before a model may be evaluated multiple times.
See also
-
teardown
() [edit on github]¶ Called after a model may be evaluated multiple times.
See also
setup()
-